Bent track from a backed-into bumper or a worn roller riding rough can pull a door clean off its rails. We fix the immediate problem and the root cause.
Fixing the symptom without finding the cause usually means the same problem returns within weeks.
We don't eyeball alignment. Plumb and level get checked and confirmed before the job is done.
Track that's visibly bent or dented from impact gets replaced rather than hammered back into shape.
A hard impact can crack the wall bracket even when the track itself looks salvageable.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
Track sections are checked for plumb and level, then adjusted and secured to the frame at the correct tolerance.
Visibly bent or dented track sections get swapped for new standard sections rather than bent back into shape.
A roller jumping the track repeatedly usually means the rollers themselves need replacing along with the fix.
Collision damage often affects more than the visible dent. We check the full track and frame mounting system.
A track can only stay aligned if the brackets holding it are solid. We check and correct this on every off-track call.
Describing the symptom helps us bring the right track sections and hardware on the first trip.
Most off-track calls don't require a parts run thanks to a well-stocked van.
A full inspection prevents a quick patch that fails again within weeks.
The door is confirmed running smoothly on the corrected track before the job is closed out.
“Backed the truck into the door and bent the track pretty badly. Replaced the section and it runs like new.”
“Track was off plumb by more than it looked. Fixed properly instead of a quick patch.”
“Appreciated that they checked the wall brackets too, not just the visible bent section.”
A combination of a worn roller and slightly bent track is one of the most common causes we see.
We don't recommend it. Forcing a door back on the track can cause further damage or personal injury.
We'll assess the severity and recommend replacement when straightening won't hold up long-term.
Cost depends on whether it's a simple realignment or a full track section replacement, confirmed as a flat price on-site.
Continuing to run an off-track door usually causes more damage to the track, rollers, and panel.
A straightforward realignment often takes under an hour; a full section replacement may take a bit longer.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591Technicians are positioned throughout Somerset for fast response, and we cover the surrounding zip codes too.
Embedded Map Placeholder for Somerset, TX